MichaelMoore740
New member
So I got a my1020D 48v 1800w motor w/ controller and throttle that was Dec. 1st 2023 cost $117.00 and since I am disabled and with some bank and parts issues I could only go so fast. I would get the first parts right around christmas time. Of course the sprockets both motor and asle failded to work motor spun a h pattern back into a hole ( not Hardened ) axle size of shaft issue oh sorry My build is a Trike first time was front wheel hub all went togeather real nice 48v 1000w w/ 30ah 20ah and 13ah for backup. Then I got well say a wild hair after seeing the vevor motor 1800w 3 speed with forward and reverse so I started mounting in basket with it being so close to the axle any deveance in sprockets and chain causes a pretty loud pop and slight grind and with all the sprockets being 5/8 or so I thought there was always a little to a bad wobble and took me 3 times to get it worked out and the axle is 12mm and so I found the shim to fix the issue and i had only rode 50 yards as not to harm the motor or trike.then I am ready to rock and roll and the motor zip nothing and that started the very long and well kinda stupid messaging back and forth with vevor who I got direct as they show a 12 month warranty on every page. 3 weeks they ask me things or made comments about sprockets need to be 7 to 1 I never said aything concerning that and i ask what does that have to due with a motor that just quit working. Oh ya and every time they was requesting photos and video of my issue well there is not much to photo all the wiring was done with correct matching connectors I did not cut any off the controller. 3 batteries of course they complained bout them too. and then the restriction of only 5mb file of pic's and vids come on I knew they was low on these motors but they drug the whole thing out for 3 weeks till I was pretty hot around the collor. They fessed up and I only got 90.00 of my cash back I had to tear apart my pedal chopper cause i migrated the works off the trike to it and the whole thing could have been handled so much better and faster if they jut admited they was out of the things. So here I am no where but down a couple hundred for sprockets amd chain 1/4 aluminum plating for mounting lights etc and back to the orginal build and a tore apart pedal chopper so be ware of Vevor So the middle pic is how I am working on doing next month anyway that is my Vevor nightmare