Tsdz2 Kt-lcd3 problem

Kubek

New member
Local time
12:17 PM
Joined
Jan 8, 2024
Messages
1
Location
Wrocław
I purchased a TSDZ2 engine with a damaged VLCD5 display. Based on Bajkel's videos, I bought a KT-LCD3 display and an STM32 programmer from myfriend. Display on the STM8S105 processor.
pkjEpTV44IWsi1zwvOGaBuUfkQXvY_qVZTB9NrZG4i_qzbZc1gJG7p1vxLH4ArfV8rJKu6NBE2mSOPMsqfrl4WOrIzlC8or2Ik_6YsUxGfQUprcpn7lh4u9QLGXKUg6fPXG_FS8osuysNjxp981-L3w


After flashing the engine and display, I could not change the support mode :( The buttons do not change modes, even though they are functional, because I checked them with a multimeter. The files I used for flashing are those suggested by Bikel:
DSt0xQuq_EWt4tg3A3fhN8NQ94aZzfc4ImPPITox9ZJ1-zq0ERjPdO7iEjzPhMOlxyCdn3hsjl1bTHimdKU5FOi-gWrMEHp1iDHCcbOBw-RJrq_3eMF14QqYYMKVtexhOSGaqqF7z0rNX0cSAJXGL1c


Reprogramming to KT LCD3 TSDZ2 V20.1C.4 and v0.18 did not change anything.
I bought another display from majfriend. Here with the MM32SPIN processor.
611-eidZJClKFLBMzGE1PESeTX0g6Nf2b3kgmUWmAXcOWUWkbMeX32aGvD4ZroZlnpHy5rdsDGWV73e2GlRMwAu8kt2T26idXU0MZSLvc6PuhUaHe5GLkNTjVx6Bw7WQAnybQkFBSQUejylvtlnMlAk


This time there is no communication between the programmer and the display. I cannot reprogram it.
I bought a board and additional programmers, after checking, it turns out that the programmers are functional.
F3i68MjQlPlZhG4QM6aotcqv3ihjhpQHtdYKzil9vP5ZticAzYfwBtZPUDRRTxj8TxZU7vAIJ9CwmjS_5gX8rTGQAYzzOAFBAgDbRymAoLtY8fJDI6ci3L29Q08JaclXSJ4wamaId5qBNzng-O0XoLg


And now the question is what to do with it? so that the bike can run and you can use all the great things that open source software offers?
 
Back
Top