I’m a life long cyclist from Cheshire, England. I built an ebike using a bafang 1000w, 52v mid drive which has been trouble free for about four years fitted to a camarra mountain bike.
i recently got curious about programming the controller as there were a few setting I have wanted to change. So I bought the cable and downloaded the software as well as ins the required drive onto pc.
all appeared to go well, the motor connected to the pc via the luna programme, I read data from motor made a few small changes and wrote them to motor. This is where it all went wrong; the luna software said it was still connected but the motor specs disappeared and all four read write buttons along the bottom greyed out. Despite my efforts I cannot get the software to work again; I’ve reinstalled the driver, downloaded another copy of programme and bought another cable. The programme says it’s connected but buttons still greyed out and not motor info showing. The worst thing is the motor no longer works via pedal or throttle although the display and lights are ok.
I haven’t a clue what to do now to resolve the problem but only hope someone on the forum with far superior knowledge and experience than me can provide some much needed advice.
kevin
i recently got curious about programming the controller as there were a few setting I have wanted to change. So I bought the cable and downloaded the software as well as ins the required drive onto pc.
all appeared to go well, the motor connected to the pc via the luna programme, I read data from motor made a few small changes and wrote them to motor. This is where it all went wrong; the luna software said it was still connected but the motor specs disappeared and all four read write buttons along the bottom greyed out. Despite my efforts I cannot get the software to work again; I’ve reinstalled the driver, downloaded another copy of programme and bought another cable. The programme says it’s connected but buttons still greyed out and not motor info showing. The worst thing is the motor no longer works via pedal or throttle although the display and lights are ok.
I haven’t a clue what to do now to resolve the problem but only hope someone on the forum with far superior knowledge and experience than me can provide some much needed advice.
kevin