Hello.
My setup is: TSDZ2, 500W motor, 48V, 8 pin connector to display, VLCD5 display.
Issue: No power to display.
Possible cause: Short circuit of the 2 cables going to the battery from the controller(battery was not connected when this happened) but i saw arcing between the two cables, likely from the capacitors in the controller.
Tests so far:
- I have power from battery reaching controller.
- I have voltage equal to battery voltage when measuring ground to blue P+ on the 8-pin connector.
- I have no voltage when measuring ground to any of the other pins on the 8-pin connector.
Anything i can do to fix this issue, or is my controller dead?
Any suggestions on where to get a replacement with good price and delivery in/to the EU?
My setup is: TSDZ2, 500W motor, 48V, 8 pin connector to display, VLCD5 display.
Issue: No power to display.
Possible cause: Short circuit of the 2 cables going to the battery from the controller(battery was not connected when this happened) but i saw arcing between the two cables, likely from the capacitors in the controller.
Tests so far:
- I have power from battery reaching controller.
- I have voltage equal to battery voltage when measuring ground to blue P+ on the 8-pin connector.
- I have no voltage when measuring ground to any of the other pins on the 8-pin connector.
Anything i can do to fix this issue, or is my controller dead?
Any suggestions on where to get a replacement with good price and delivery in/to the EU?