I am very new to ebike world but have knowledge with dc electronics for long time.
Anyways I recently purchased a few of these xhunter bikes. I've only rode 1 so far and have a question about its display.
I noticed it was limited at speed to 20mph.
Their manual never mentions how to enter the program settings section but I figured it out by holding up and down together...
Now, once in, we were changing some settings we didn't know what they were for....yet...
We managed to revert everything back EXCEPT for one setting.
P07.
If I remember correctly, P07 was defaulted to 0.
There is a range of this from 0000 - 0006.
It was bumped to 0006... but here is problem.
This affects the speedometer. When I'm going ~ 28-30 according to GPS, bike only reads ~7-7.5mph.
When I go back into P07 to change, the number flashes waiting for me to change it but the up or down arrow no longer works in P07 section....
That makes no sense to me so I am stumped on how to change it.
Anyways I recently purchased a few of these xhunter bikes. I've only rode 1 so far and have a question about its display.
I noticed it was limited at speed to 20mph.
Their manual never mentions how to enter the program settings section but I figured it out by holding up and down together...
Now, once in, we were changing some settings we didn't know what they were for....yet...
We managed to revert everything back EXCEPT for one setting.
P07.
If I remember correctly, P07 was defaulted to 0.
There is a range of this from 0000 - 0006.
It was bumped to 0006... but here is problem.
This affects the speedometer. When I'm going ~ 28-30 according to GPS, bike only reads ~7-7.5mph.
When I go back into P07 to change, the number flashes waiting for me to change it but the up or down arrow no longer works in P07 section....
That makes no sense to me so I am stumped on how to change it.