Twickert
New member
Hello i’m new to the forum from Springfield Illinois. I just got my first bike about a year ago a wooken fat-tire … about two months ago, my tire spun off ripping the cable out of the out and severing a few wires .
I had since bought a new cable and installed it and it worked for about 15 minutes then nothing so then I replaced the three hall sensors on the board however, there is one more sensor that is kind of raised off the board that I do not know what to do with….. possibly a speed sensor?
Any way now my speedometer does not work and it will turn on and run for a little bit and then cut out with a 007 error code and a blinking controller that blinks six times does anybody know what this problem could possibly be? (I’m not the best solderer and I noticed on the board one of the hall sensor lines was severed so I jumped it. That is why there’s that wire in the middle of the board on the picture.)
I appreciate any and all answers.
Thank you for your time
I had since bought a new cable and installed it and it worked for about 15 minutes then nothing so then I replaced the three hall sensors on the board however, there is one more sensor that is kind of raised off the board that I do not know what to do with….. possibly a speed sensor?
Any way now my speedometer does not work and it will turn on and run for a little bit and then cut out with a 007 error code and a blinking controller that blinks six times does anybody know what this problem could possibly be? (I’m not the best solderer and I noticed on the board one of the hall sensor lines was severed so I jumped it. That is why there’s that wire in the middle of the board on the picture.)
I appreciate any and all answers.
Thank you for your time
