wheel

[psprom15]

this i converted to e bike the orig wheel didn't have a moter and was skinnier then this 1


when i got this wheel it was fatter cuz it has a moter inside,my fork is wide at the base to fit the screws on each side then it goes skinny as it goes up
now the tire is rubbing on the fork any ideas to make it flatter, i think it straight enough to go threw w/o rubbing but maybe need something so it flat?

i mean 1 side of the hub moter is thick so it pushes the wheel to 1 side now the other side of the wheel is to close to the fork, its rubbing on it

can i make it so the wheels in the middle like a norm bike

 

[psprom15]

this

 

[Chuy]

Either the axle is not set properly, or the wheel dishing is set incorrectly.

 

[DieselTech]

To me! It looks like your hub motor is too wide for the wheel dropouts on your bike. Measure between your wheel dropouts in mm. Then measure your hub motor axle width at the inner axle nuts on the hub motor. In mm & post back.

 

[DieselTech]

I think your fork is too narrow. I think you got a 110mm fork dropouts with a 135mm hub motor width. Or you got a 135mm fork dropouts & a 175mm hub motor width. I maybe be wrong. But that's my guess.

 

[DieselTech]

Your are going to need a different/new front fork assembly.