Powabyke intermittent runner

sam

New member
Local time
9:09 PM
Joined
Jun 21, 2018
Messages
14
I am trying to sort a Powabyke intermittent runner out, have checked all plugs and actually soldered two joints to bypass the bad plugs but I am wondering if the controler is at fault but is it a brushed or brushless?

The bike is a shopper and about 6 or so years old. there are only two connections to the wheel so I am thinking it's brushed but when I removed the hub casing there was another unit inside that was the motor (1/2 the width of hub) and a gear box/ drive relay (all in one total casing) but I could not see any external brush mounts. Any thoughts?
 
Unhook the battery for 15 min, then reconnect the cables, check all connections again.
 
Back
Top