silentmac
New member
- Local time
- 6:29 PM
- Joined
- Sep 24, 2022
- Messages
- 1
Hello , last week I got the dreaded error 7 /hall or motor fail . I notice my cable was frayed at the entry point to the hub , so I replaced the while cable and resoldered.
I had a feeling that wasn't the only issue and I was right , still getting the error 7 , so i checked the hall sensors straight on the board.
So I'm checking each positive and negative connection on the 3 hall sensors , each one is giving me a reading of 8v which I think is strange, usually you should get a reading of 5v .
Then I check each signal connection on the hall sensor .
Sensor 3 has comes up 0 .
Anyone know what's going on ?
Thank you
I had a feeling that wasn't the only issue and I was right , still getting the error 7 , so i checked the hall sensors straight on the board.
So I'm checking each positive and negative connection on the 3 hall sensors , each one is giving me a reading of 8v which I think is strange, usually you should get a reading of 5v .
Then I check each signal connection on the hall sensor .
Sensor 3 has comes up 0 .
Anyone know what's going on ?
Thank you
