New Zeegr S1 user

[jbentley24]

I recently purchased a Zeegr S1 and have had it out a few times. The documentation is very poor. They provide a User's Manual that shows how to change all of the settings, but there is no info on what effect i would experience from the setting choices. For instance, i can change the PAS pedal assist level, but no info on what this will effect. If i don't want to pedal, where do i set PAS? If i want to pedal some of the time, where do i set PAS? Is there a downside to setting the PAS for no pedaling, and then I try to pedal. Also, no info on how to switch off the front hub. There is a Single Dual pushbutton switch but no indicator to say which mode it is set in.

 

[addertooth]

Any PAS setting above zero (0) allows you to use the throttle. The higher the PAS setting, they higher the top speed the throttle gives you.
I max out at about 32 MPH on PAS 5.
There is a red button on the left side of the handlebar for turning the front motor on and off.
You can hear a hum coming from the front motor when it is working; you will also notice your acceleration is stronger.

I have one of these bikes, and have about 700 miles on it. See picture below.

 

[HumanPerson]

Any PAS setting above zero (0) allows you to use the throttle. The higher the PAS setting, they higher the top speed the throttle gives you.
I max out at about 32 MPH on PAS 5.
There is a red button on the left side of the handlebar for turning the front motor on and off.
You can hear a hum coming from the front motor when it is working; you will also notice your acceleration is stronger.

I have one of these bikes, and have about 700 miles on it. See picture below.
View attachment 13990

If i ever move to your state i'm coming to ride with you for a while

 

[addertooth]

Is it because I always pack a tool kit, patch kit, compressor and medical kit?

 

[HumanPerson]

Is it because I always pack a tool kit, patch kit, compressor and medical kit?

nah, i gots me own

I just liek the cut of your jib sometimes, that's all. Carry on!