New Member from Buffalo, NY

[Nancyjam]

Hey Everyone, I'm from Buffalo, NY.

 

[Snoop]

Hey Everyone, I'm from Buffalo, NY.

Hi Nancy!

I’m another Western NY’er.

Welcome to the forum, and Go Bills!

 

[HumanPerson]

Welcome to our humble home

 

[rdicus7]

Hi I'm Bob Dicus and am new to the forum. I'm installing an Ebikeling front hub motor 48 volt 1200 watt motor. I have it running with throttle fine. PAS only works when pedalling backwards. I am confused not knowing what to do to correct. Any ideas?

 

[procreator]

Did you install the cadence sensor on the correct side of the crank?

 

[rdicus7]

Did you install the cadence sensor on the correct side of the crank?

I installed it on the non drive side.

 

[rdicus7]

I placed the MOSFET's on non drive side of trike.

 

[rdicus7]

I placed the MOSFET's on non drive side of trike.

 

[procreator]

Is it possible there is a wiring problem somewhere?

 

[rdicus7]

We have it working intermittently but I can't find a permanent mounting solution where it works all the time.

 

[rdicus7]

It sure could be, but I suspect the MOSFET's & sensor are defective. I'm going to try a couple of different ones and see.

 

[Jimish32]

Thanks guyss, I am new here, from San Francisco, happy to meet such helping community

 

[HumanPerson]

Welcome to the forums @Jimish32

 

[walschuler]

I am relatively new to this e-community and site, and also in SF

 

[JerryB]

Lot new folks on this thread.....welcome all......we're really nice folks.....good lookin too! Enjoy.