Juiced Scrambler X2 only works in walk mode

[Annieolnie]

Can you link me to that one and the display please

You know I can't link but I will put a pic here and a store number. It's actually 35 amps which I will reset. Aliexpress has become even more esoteric since the tariffs. The price on this was so reasonable I just grabbed it. It's going to need a motor plug adapter probably for me and anyone else, but I'm not sure which exact one until I see it. I think it's coming with a larger Bafang plug. Affordable ebikes in Canada has a number of adapters. I'm using the LCD-7C display, just because I have it and it auto sets to 52 volts. I'm hoping the tariffs will change in Oct. and make life more reasonable.

 

[HumanPerson]

Thank you

 

[Annieolnie]

Here are some pictures of the controller that I am trying to find a replacement for. If any of the Juiced specialists out there could help answered my question about the whether a Ripcurrent controller would work? Looks like a close match but is 30A rather than 25A and there seems to be an extra wire. View attachment 21863

Just to note, your motor plug (the red one) is a L1121. The picture below is not your adapter, but it shows the plug. You will need a female one on an adapter and the opposite end will be the male to match whatever plug your controller comes with. Write that on your arm or something, because when you start configuring it all, it can become confusing. The rectangle is xt60 and can easily be adapted. The yellow male is, I think your throttle? I have to look into that. You might need to go over to a KT throttle, which is very doable. The eight or nine pin is your display and you will have a KT display so that will match. You may need the KT harness wire, which is also easy to do. You can see how this all starts to fit together. People do go down this road quite often, so don't get discouraged. Read the other thread and see what questions you have.

 

[Emotional-Macaron-66]

Just to note, your motor plug (the red one) is a L1121. The picture below is not your adapter, but it shows the plug. You will need a female one on an adapter and the opposite end will be the male to match whatever plug your controller comes with. Write that on your arm or something, because when you start configuring it all, it can become confusing. The rectangle is xt60 and can easily be adapted. The yellow male is, I think your throttle? I have to look into that. You might need to go over to a KT throttle, which is very doable. The eight or nine pin is your display and you will have a KT display so that will match. You may need the KT harness wire, which is also easy to do. You can see how this all starts to fit together. People do go down this road quite often, so don't get discouraged. Read the other thread and see what questions you have.
View attachment 21882
View attachment 21881

Thank you for all this information. Unfortunately it doesn’t stop there with the Juiced. The wiring harness has these screw connectors for the brakes, display and throttle. I would need an adaptor or have to replace those too.

 

[Annieolnie]

Your display plug would already be switched out. There are a couple of different brake cut off options, including the stick on type. If can pull out your sensor and post a picture, it would help. Also, what does your throttle look like? What it comes down to is that you are basically rebuilding an ebike. The most expensive parts of any ebike are the motor, the battery and the frame, if those are in good shape, then there is reason to do this. It just comes down to what you decide you really want. I would guess it's a little overwhelming trying to do 2 bikes. You could just do one and see how that turns out, before you go on to the next. These little in-between parts are not very expensive.