Hi, not sure if this has been covered, didn't find anything on a search. I can't see my indicators on my bumblee sting, and the indicator switch is a three way rocker, which stays put. Apart from a very small flashing symbol on one lcd clock, I keep forgetting to cancel it. Any ideas on a fix? Some of the 'real' bikers at work suggested a buzzer, but as the whole on/off cct is inside the led indicators, with no flasher relay, this would buzz continuosly whilst indicating. I d either going to add a small 6mm green repeater on my handle bar( yes, also on all the time but not as annoying) or replace the front indicators with a pair where I can see the light on at the edge
Indicator 'dash' repeater
- Thread starter av02
- Start date
It might help to have some clue what exactly you are indicating or wanting to cancel.
If you are forgetting to turn it off, most do this automatically with no throttle input for 3-5 minutes.
Pictures are also very useful.
If you are forgetting to turn it off, most do this automatically with no throttle input for 3-5 minutes.
Pictures are also very useful.
The turn indicator. The switch is non cancelling, and won't cancel after a set time. You have to flick the switch back to the middle. Sounds obvious, but my first moped, so keep forgetting. And from my seated position, can't see the indicator is on. There is a very small indication on the lcd clock , but again, not too obvious. I'll post a pic when I can.
So came up with quite a good solution. Got a replacement set of turn indicators which have blue led arrows on the back casing, which I can see. Almost direct replacement. Just had to do a bit of soldering to splice in the new ones and keep the original connectors .
