In between Speed

[Eagle6]

Not quite sure if this will solve my current situation but here goes….
When I use my PAS in 2nd mode, it is to fast and easy to pedal. When I drop it down to 1st mode it is too slow and very hard to pedal. I wish I could adjust it somehow to have the 2nd mode go slower or give me alittle bit more resistance.
Not complaining, just looking to fine tune my biking experience! Any suggestions?

 

[JerryB]

Not sure what ebike you have.....does it have a gear shifter? I understand your problem.....on my ebike.....when I move into different PA mode.....I shift up or down to adjust my pedal speed. In fact.....I use my 7 speed gear shifter more than my PA options. I ride in PA 1 about 90% of the time and adjust the gears for hills or terrain.

 

[Penfield E. Farthing]

It is adjustable on a Magicbike. One of the few good things I can say about it.

 

[bdr1340]

Not quite sure if this will solve my current situation but here goes….
When I use my PAS in 2nd mode, it is to fast and easy to pedal. When I drop it down to 1st mode it is too slow and very hard to pedal. I wish I could adjust it somehow to have the 2nd mode go slower or give me alittle bit more resistance.
Not complaining, just looking to fine tune my biking experience! Any suggestions?

I have the same issue and just reset my pedal assist power levels differently from factory setting’s today. I found and used the recommended settings I found here on this forum. Which bicycle model do you have? A lot of these e-bikes allow you to adjust the power percentage levels delivered for each pedal assist number.

 

[bdr1340]

P12 setting Enables you to adjust motor responsiveness from 0 - 3 gradual to quick response) Factory settings are at 2 according to the manual.

 

[Eagle6]

Not sure if I can adjust/change my settings. No options on my screen. I have a Bee Cool Adventurer.

 

[Django]

The issue may have to do with your bike having a cadence sensor rather than a torque sensor. Maybe Bee Cool’s tech people could help.