Hub motor only moves when in learning mode

[brianbonedoc]

I hope someone can help. I have a 36v geared hub motor from aliexpress. Has 3 phase wires and 5 hall sensor wires. I have tried 3 different brushless controllers from amazon. On all 3 I can connect everything but nothing works EXCEPT for learning mode. Once I connect the learning wires the motor runs smoothly. But after I disconnect the learning wires, I dont have any motion when trying to use the throttle. I have tested 2 throttles and I get the .8-4.2v on the signal pin as I move it. I did try moving the phase wires around, but I get the same situation, no motion except during learning mode.

Pulling my hair out. Thanks!

https://www.aliexpress.us/item/3256...2TGAl9I&gatewayAdapt=glo2usa&_randl_shipto=US