Zeniaosa
New member
Hi everyone,
I have a Kunteng KT3648/52SVPR controller (sinusoidal, 36/48/52 V, 22 A nominal / 45 A peak, for DD motor ~1500 W). I would like to ask if anyone can help with a firmware that meets my specific requirements.
My goals and requirements:
I don’t have programming knowledge, so I need a ready-made firmware that can be flashed directly using KT-Flash Tool.
If anyone has already done something similar or can help create such a firmware, I would greatly appreciate your assistance and advice.
Thank you very much in advance!
I have a Kunteng KT3648/52SVPR controller (sinusoidal, 36/48/52 V, 22 A nominal / 45 A peak, for DD motor ~1500 W). I would like to ask if anyone can help with a firmware that meets my specific requirements.
My goals and requirements:
- When the VOC / Speed Limit wire is connected:
- PAS speed should be strictly limited to 25 km/h (≈15.5 mph).
- Throttle should be limited to 6 km/h (≈3.7 mph), no more (like Walk Assist).
- It should not be possible to increase the speed via the display while the wire is connected.
- When the wire is disconnected:
- Throttle and PAS work normally, without limits.
- It should work with standard KT displays (e.g., S966 or LCD series).
I don’t have programming knowledge, so I need a ready-made firmware that can be flashed directly using KT-Flash Tool.
If anyone has already done something similar or can help create such a firmware, I would greatly appreciate your assistance and advice.
Thank you very much in advance!
