ok where to start, picked up an amazon return 26inch cliensy fat tire mountain bike 36 volt , missing battery and charger with wiring pulled out.
the good, got a new battery and charger, obvious wiring, power and 3 phase, hall connector and 6 pin display.
my issue is with the 4 three pole connectors, i have lights and horn and display showing error code 8 ,i have pedal assist from motor ,but no straight battery power or throttle.
i am running in to dead ends for a schematic and went to a bike shop and was told i would need an electrician ,from controller i have 2 connections joined orange/ black and common green, also have a green with red stripe ,red and black feed and third red yellow blk.
i believe the red yellow and blk are the pedal assist which goes to yellow blue red to bike. then i have 3 left have 2 red black green and one blue red black anyone have a similar that might know the correct wiring from there any and all help would be appreciated.
the good, got a new battery and charger, obvious wiring, power and 3 phase, hall connector and 6 pin display.
my issue is with the 4 three pole connectors, i have lights and horn and display showing error code 8 ,i have pedal assist from motor ,but no straight battery power or throttle.
i am running in to dead ends for a schematic and went to a bike shop and was told i would need an electrician ,from controller i have 2 connections joined orange/ black and common green, also have a green with red stripe ,red and black feed and third red yellow blk.
i believe the red yellow and blk are the pedal assist which goes to yellow blue red to bike. then i have 3 left have 2 red black green and one blue red black anyone have a similar that might know the correct wiring from there any and all help would be appreciated.