Fitting new controller wiring question - Cyclomatic cx2

[blooka]

hI guys
i am just fitting a new speed controller and led to the wifes Cyclomatic cx2
just wanted to make sure i am connecting the wires correctly.
the first picture shows the 2 block connectors 5 wires that go to the motor i presume they are they connected colour to colour?
the other picture is of the connector to the pas crank sensor just not sure if they are correct or need swapping around i just dont want to blow anything lol
hope you can help a newbie
cheers

 

[Freddy1]

It's reasonable to start with the assumption that the motor colours match. They may not as there is no wiring standard but it reasonable to start with the hope they likely do.

But the pas connection definitely looks wrong to me. I would assume the red wires should match. That leaves you with figuring out which of the yellow and blue wires is the earth to match the black and which is the signatory match the blue.

I use a 5v tester I made from an old 5v charger and a multi meter to figure that stuff out.

 

[Freddy1]

That should read ..... signal to match the blue