ashishgupta124
New member
So i am trying to install a new 72V 35amp wireless (smart) controller on my electric scooter.
Connected basic connections
Throttle wires
Motor Hall sensor wires
Motor phase wires
And ignition wire sorted to battery +ve
Now there was no response in motor when giving full throttle
Now i connected self learning wires ( two thing white wires shorted on connection)
Now wheel rotates on its own backwards and stops
Now i gave throttle and motor rotates fine in same backward direction.
Now i unplug and replug the self learning wires , now motor rotates on its own in forward direction and stops.
Now on giving throttle the wheel works fine like it should , motor direction is correct , everything is ok
Now i unplug the self learning wire
Now again i use throttle to check if everything is ok.
On giving throttle input the motor works fine , everything seems ok
Now i key off the scooter and remove battery
----+---------
Now i replug battery ,
Key on scooter
Now the motor is not rotating on giving throttle input , unless i reconnect the self learning wires.
Repeated all steps , its still same
Seems like settings are not getting saved when we trun off the ignition and turn back on
What should i do i am very frustrated
Connected basic connections
Throttle wires
Motor Hall sensor wires
Motor phase wires
And ignition wire sorted to battery +ve
Now there was no response in motor when giving full throttle
Now i connected self learning wires ( two thing white wires shorted on connection)
Now wheel rotates on its own backwards and stops
Now i gave throttle and motor rotates fine in same backward direction.
Now i unplug and replug the self learning wires , now motor rotates on its own in forward direction and stops.
Now on giving throttle the wheel works fine like it should , motor direction is correct , everything is ok
Now i unplug the self learning wire
Now again i use throttle to check if everything is ok.
On giving throttle input the motor works fine , everything seems ok
Now i key off the scooter and remove battery
----+---------
Now i replug battery ,
Key on scooter
Now the motor is not rotating on giving throttle input , unless i reconnect the self learning wires.
Repeated all steps , its still same
Seems like settings are not getting saved when we trun off the ignition and turn back on
What should i do i am very frustrated