Daymak Vienna B 2010

JJM

New member
Local time
8:12 AM
Joined
May 29, 2023
Messages
1
Location
Winnipeg, Canada
I have a vienna b, controller burnt so i bought a replacement daymak dmk1291 controller and can’t figure it out. There is a lot of spare wires from the controller but which ones are absolutely necessary to make the bike operate?
-antitheft
-reverse
-PAS
-low brake
-high brake
-manual cruise
-phase line meter
-3 speed
-bluetooth
 
You must have phase wires, and on most, Halls. Three thick phase then 5 thin Halls, two of those are red and black for power. 3-speed Switch or most default to low speed, then either PAS or throttle. Not sure what a phase line meter is, or a power readout, likely not mandatory if three phase connected already.
 
Back
Top