addmotor etrike m334 error code 01

Desten

New member
Local time
11:36 AM
Joined
Dec 11, 2024
Messages
6
Location
Repton, Al
I posted on newbe thread I'm having problems with error code 01. I've replaced the motor due to pinched wiring at the motor and corrected the error momentarily but after the bike sits untouched for approx, 1 minute the error comes back, I disconnect battery and reapply power , error clears and after another 1minute it comes back.. I'm thinking it may be some component getting hot on thermal overload and shutting itself down.. Anyone with any info will be greatly appreciated
 
I had that problem with a display that got dropped before installation.
the circuit board just had crack that shut everything off after being on for a few minutes then when i would go to throttle it it would die.

Alot of checking of the controller board and the display board.
 
If ya need to get a new controller or display try to lower the current..start low then work up to what will work for you.
 
Ok, so I think I have the error worked out, trike is operational but am now getting slight motor surges at all speeds and speedometer is extremely out of range and I can't find any info on recalibration,, ie. at first movement speedo is reading 18mph + and ramping up to over 100mph as actual speed increases. up to around 20mph I've checked and rechecked all connections and can find no problems anywhere with connections. tire size is set to 20" , max speed at 32mph and measuring unit at mph
 
Back
Top